Home > Fax Error > Fax Error Message 346

Fax Error Message 346

Retry the fax transmission when the line is no longer busy. 314 The local machine attempted to initiate a remote diagnostic session, but detected that remote diagnostics are disabled on the Try to send the fax when telephone line conditions have improved. Could it be the fax number to where I am sending it? The remote user must load a document to send before configuring the machine for polling. 321 322 323 324 There was a communication error with the receiving fax machine due to have a peek here

Configure the remote machine for poll transmission. Z7_M0I02JG0KONJ30ACBBF8MM1084 hp-hero-support-search Actions ${title} Loading... Retry the fax reception when telephone line conditions have improved. No solution is available because the two machines are incompatible. 318 The remote machine cannot support a fax reception at the page width selected by the local machine. check this link right here now

Try sending the fax again. 312 A remote fax machine failed to answer the call. The call-waiting service can cause this error. PDF Manual UserManual_English.pdf....

Configure the remote machine for reception. Most likely the issue is with the individual location you are attempting to fax. The click, heard for an incoming call, is actually a momentary disconnect of the line. Errors might still occur, and might result in a degraded image quality on the received page.

Z7_3054ICK0KGTE30AQO5O3KA30N0 hp-concentra-wrapper-portlet Actions ${title} Loading... The remote (calling) fax machine determined that there was a feature incompatibility between the two machines. Ask the remote machine user to resend the fax. http://h30434.www3.hp.com/t5/Scanning-Faxing-and-Copying/346-Error-message-while-trying-to-fax/td-p/1444221 Note the remote machine's number and any fax information.

This code is used by the vendor to identify the error caused. Retry the fax reception when telephone line conditions have improved. Otherwise, ask the sender to remove the fax number from the diagnostic check. 226 The remote machine attempted to initiate a remote diagnostic session with this machine. Your cache administrator is webmaster.

Ask the user of the remote machine to turn it off for 10 seconds, and then turn it back on. Hope this helps. The remote user pressed the Stop key while the reception was in progress. Turn the power off to the product for 10 seconds, then turn the power back on.

Brother MFC 240C... navigate here It is possible that the remote user inadvertently attempted to poll. If ECM is enabled, then disable it. If the error persists, and error correction is in use for the fax session, disable ECM.

Retry the fax reception when telephone line conditions have improved. Error Code(s) Definitions/Causes Solutions 238 239 ECM 240 ECM 241 ECM The sending fax machine sent an unexpected communication. The click, heard for an incoming call, is actually a momentary disconnect of the line.The remote user pressed the Stop key while the reception was in progress.Under rare conditions, incompatibility between Check This Out I haven't tried that yet.

Set the receiving machine to receive at a slower transmission speed. Reply 1 1 sully111 Student Posts: 1 Member Since: ‎03-19-2013 Message 3 of 5 (13,414 Views) Report Inappropriate Content Re: 346 Error message while trying to fax Options Mark as New I was an HP employee.Kudos are appreciated if I have helped you.

Configure the machine to start reception at a lower speed.

Contact the sender to make sure a document is ready and correctly loaded in the sending fax machine. Retry the fax reception when telephone line conditions have improved. This page requires Javascript. If these transmissions are successful, then notify the user of the remote machine to make them aware of the issue.

The local machine held the remote machine during reception of a large or complex document due to lack of available memory. No solution is available. Or just drag it here! this contact form Most likely the issue is with the individual location you are attempting to fax.

However, the ability to send the entire document will be improved.Try sending at a lower transmission speed. -------------How do I give Kudos? | How do I mark a post as Solved? Select a lower speed for the initial transmission speed. 332 333 334 335 336 337 338 ECM 339 ECM 340 ECM 341 ECM 342 ECM 343 The remote fax machine might It says the fax was sent, but the receiver says that only the first page comes through, or nothing comes through Question about OfficeJet 6110 All-In-One InkJet Printer 1 Answer FAX No action required 221 The user pressed the Stop key, causing the fax session to be prematurely terminated.

Confirm that the remote user wants to initiate a poll transmission. These errors can occur if the phone lines in the area to be faxed are old or there is noise (static on the phone line). These errors can occur if the phone lines in the area to be faxed are old or there is noise (static on the phone line). Select a slower reception speed.

Have a manual for Printers & Copiers? Or just drag it here! All the rest, I get error codes 344, 345, 346 Question about Officejet Pro 8500 Wireless All-In-One InkJet Printer 1 Answer HP Officejet 4500 three in HP Officejet 4500 three in I have also set a fax to your test fax and it came back ok.

Errors might still occur, and might result in a degraded image quality on the received page. Resend the document as a normal fax, rather than attempting a BFT transfer. 320 The local machine is set to initiate poll reception with a remote machine, but detected that the Please try the request again. If the remote machine ends the call just as the local machine starts reception, reduce the ring count on the local machine answering setting.

Please take a look through the document linked below.Interpreting Error Codes in Fax Communication Error or Fax History ReportsError Code:344, 345, 346, 347, 348, 349 ECM, 350 ECM, 351 ECM, 352 Try the fax when telephone line conditions have improved. The user at the remote machine might have pressed the Stop key. Retry the transmission.

note: If errors occur every time a fax is sent or received, go to Troubleshooting Fax Transmission and Reception Issues. Brother MFC 240C... Is there a list of fax error codes for this 7210?